Bolid Signal-10 Uživatelský manuál stáhnout pdf (Strana 86)

Orion ISS

Save Results

When key handling is completed, the amended key list MUST BE WRITTEN to the Signal-10 memory

by means of Write Keys to Memory tool (pressing the

button).

NOTES: After activation the described command all previously written keys at the device

memory are cleared

The key memory area is isolated from other memory areas and is handled separately.

To save keys, use only the toolbar Write Keys to Memory tool rather than other UProg

save commands.

The keys with their attributes can also be written to a special file with the extension of .ki which then

can be loaded to an UProg at this/another PC, for example, to facilitate setting of other Signal-10 de-

vices. The Save Keys to File command (the

toolbar button) is to be used for this purpose.

Programming of Keys by Hardware

For hardware programming of User keys (which are intended for arming/disarming alarm loops of this

device), the device should be switched to the User Key Programming mode by presenting a Master

key to the device reader (see Section Electronic Keys).

Also one Master key can be programmed by hardware.

Programming of a Master Key by Hardware

As opposed to Master key programming by means of UProg Configuration Tool (see above) only one

Master key can be programmed by hardware.

WARNING: Each hardware programming of a new Master key causes all keys stored in the device

memory to be deleted.

In order to switch the device to the Master Key Programming Mode, press the device tamper by a

specific way: long pressing – short pressing – long pressing. If you successfully pressed the tamper

switch as mentioned above, the device plays the first part of the Programming melody while READY

LED and the reader LED start flashing.

Then, within 10 seconds touch the device reader with an electronic key. If the device successfully

reads the code of the presented key, it deletes all memorized keys and writes the new key code to its

memory with the Master attribute and the status enabling the key to arm/disarm all the 10 alarm loops

of the device. After that the device exits from Master Key Programming Mode.

www.bolid.com 86

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 95 96

Žádné komentáře

Bolid Signal-10 Uživatelský manuál Strana 86